Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013

Authorised by the Chief Parliamentary Counsel Authorised Version i Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013 S.R. No. 133/2013 TABLE OF PROVISIONS Regulation Page 1 Objective 1 2 Authorising provision 1 3 Commencement 1 4 Definition 2 5 Revocation of regulations 32, 33, 34 and 37 2 6 Savings provision 2 277 Savings provision—fees for certification of compliant system of electronic stability control 2 7 Amendment to Schedule 2 3 8 Amendment to Schedule 5 3 ═══════════════ ENDNOTES 4 -- 1 of 5 -- Authorised by the Chief Parliamentary Counsel Authorised Version 1 STATUTORY RULES 2013 S.R. No. 133/2013 Road Safety Act 1986 Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013 The Governor in Council makes the following Regulations: Dated: 29 October 2013 Responsible Minister: TERRY MULDER Minister for Roads YVETTE CARISBROOKE Clerk of the Executive Council 1 Objective The objective of these Regulations is to amend the Road Safety (Vehicles) Regulations 2009 to ensure that the requirements of Schedule 2 relating to the fitting of electronic stability control in certain vehicles do not apply to vehicles manufactured from 1 November 2013. 2 Authorising provision These Regulations are made under section 95 of the Road Safety Act 1986. 3 Commencement These Regulations come into operation on 1 November 2013. -- 2 of 5 -- S.R. No. 133/2013 Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013 2 Authorised by the Chief Parliamentary Counsel 4 Definition In regulation 5 of the Road Safety (Vehicles) Regulations 2009 1 , in the definition of compliant system of electronic stability control— (a) in paragraph (b), for "33;" substitute "33 as in force before 1 November 2013; or"; (b) after paragraph (b) insert— "(c) complies with ADR 31/02 or ADR 35/03;". 5 Revocation of regulations 32, 33, 34 and 37 Regulations 32, 33, 34 and 37 of the Road Safety (Vehicles) Regulations 2009 are revoked. 6 Savings provision After regulation 276 of the Road Safety (Vehicles) Regulations 2009, insert— "277 Savings provision—fees for certification of compliant system of electronic stability control The fee prescribed under regulation 34(3)(b)(iii), as in force immediately before the commencement of the Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013, may be charged after that commencement if— (a) the application for certification under that regulation was made before 1 November 2013; and (b) the compliant system of electronic stability control for a vehicle or model of vehicle was certified under regulation 32, as in force immediately before the commencement of the Road Safety (Vehicles) Amendment r. 4 -- 3 of 5 -- S.R. No. 133/2013 Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013 3 Authorised by the Chief Parliamentary Counsel (Electronic Stability Control) Regulations 2013.". 7 Amendment to Schedule 2 (1) For clause 175(1)(b) of Schedule 2 to the Road Safety (Vehicles) Regulations 2009 substitute— "(b) that was manufactured on or after 1 January 2011 and before 1 November 2013—". (2) At the foot of clause 175(1) of Schedule 2 to the Road Safety (Vehicles) Regulations 2009, insert— "Note Vehicles referred to in this clause that are manufactured on or after 1 November 2013 are required to be fitted with electronic stability control under the third edition ADR 31/02 or third edition ADR 35/03". (3) In clause 175(2)(d) of Schedule 2 to the Road Safety (Vehicles) Regulations 2009, after "37" insert "as in force before 1 November 2013". 8 Amendment to Schedule 5 Item 6 of Schedule 5 to the Road Safety (Vehicles) Regulations 2009 is revoked. ═══════════════ r. 7 -- 4 of 5 -- S.R. No. 133/2013 Road Safety (Vehicles) Amendment (Electronic Stability Control) Regulations 2013 4 Authorised by the Chief Parliamentary Counsel ENDNOTES 1 Reg. 4: S.R. No. 118/2009. Reprint No. 1 as at August 2013. Reprinted to S.R. No. 87/2013. —— Table of Applied, Adopted or Incorporated Matter The following table of applied, adopted or incorporated matter is included in accordance with the requirements of regulation 5 of the Subordinate Legislation Regulations 2004. Statutory rule provision Title of applied, adopted or incorporated document Matter in applied, adopted or incorporated document Regulation 4 which amends the definition of compliant system of electronic stability control in regulation 5 Third edition ADR 31/02 Third edition ADR 35/03 The whole The whole Endnotes -- 5 of 5 --