Road Safety (General) (Speed Measuring Devices) Regulations 2002
i
Road Safety (General) (Speed Measuring Devices)
Regulations 2002
S.R. No. 90/2002
TABLE OF PROVISIONS
Regulation Page
1. Objective 1
2. Authorising provision 1
3. Principal Regulations 1
4. Definitions 2
5. Additional automatic detection device 2
6. Use of automatic detection devices 2
7. Additional speed measuring device 2
8. Testing of speed measuring devices 3
9. Sealing of automatic detection devices 3
═══════════════
ENDNOTES 4
-- 1 of 5 --
1
STATUTORY RULES 2002
S.R. No. 90/2002
Road Safety Act 1986
Road Safety (General) (Speed Measuring Devices)
Regulations 2002
The Governor in Council makes the following Regulations:
Dated: 24 September 2002
Responsible Minister:
PETER BATCHELOR
Minister for Transport
HELEN DOYE
Clerk of the Executive Council
1. Objective
The objective of these Regulations is to prescribe
an additional automatic detection device and an
additional speed measuring device.
2. Authorising provision
These Regulations are made under section 95 of
the Road Safety Act 1986.
3. Principal Regulations
In these Regulations, the Road Safety (General)
Regulations 1999 1 are called the Principal
Regulations.
-- 2 of 5 --
S.R. No. 90/2002
Road Safety (General) (Speed Measuring Devices) Regulations
2002
2
4. Definitions
In regulation 105 of the Principal Regulations—
(a) in the definition of "control unit", after
"means" insert "the part of an automatic
detection device referred to in regulation
302(d), (e) or (f) that is";
(b) in the definition of "speed calculation unit",
for "regulation 302(d) or (e)" substitute
"regulation 302(d), (e) or (f)";
(c) in the definition of "vehicle detectors", for
"regulation 302(d) or (e)" substitute
"regulation 302(d), (e) or (f)".
5. Additional automatic detection device
In regulation 302 of the Principal Regulations—
(a) in paragraph (e), for "System." substitute
"System; and";
(b) after paragraph (e) insert—
"(f) the automatic detection device known
as the Poltech SafeCam Mk 1.".
6. Use of automatic detection devices
In regulation 303 of the Principal Regulations—
(a) for "81 and 83A(1)" substitute "81, 83A(1)
and 84(7)";
(b) in paragraph (c), for "regulation 302(d) or
(e)" substitute "regulation 302(d), (e) or
(f)";
(c) in paragraph (c)(iv)(C) for "a locked
housing" substitute "one or more locked
housings".
7. Additional speed measuring device
In regulation 305(a) of the Principal Regulations,
for "(d) and (e)" substitute "(d), (e) or (f)".
r. 4
-- 3 of 5 --
S.R. No. 90/2002
Road Safety (General) (Speed Measuring Devices) Regulations
2002
3
8. Testing of speed measuring devices
In regulation 306 of the Principal Regulations—
(a) for "sections 79 and 81" substitute "sections
79, 81 and 84(7)";
(b) in paragraph (b)(i), for "regulation 302(d) or
(e)" substitute "regulation 302(d), (e) or (f)".
9. Sealing of automatic detection devices
In regulation 307 of the Principal Regulations—
(a) for "section 79" substitute "sections 79, 81
and 84(7)";
(b) in paragraph (a), for "regulation 302(d) or
(e)" substitute "regulation 302(d), (e) or (f)".
═══════════════
r. 8
-- 4 of 5 --
S.R. No. 90/2002
Road Safety (General) (Speed Measuring Devices) Regulations
2002
4
ENDNOTES
1 Reg. 3: S.R. No. 27/1999. Reprint No. 1 as at 1 March 2001. Reprinted to
S.R. No. 5/2001 and subsequently amended by S.R. Nos 47/2001,
57/2001, 172/2001 and 12/2002.
Endnotes
-- 5 of 5 --